|
Technical Committee No |
TC04 |
|
Status |
Replaced |
|
Category |
Metrology Sector |
|
Sub Category |
|
|
$Resources:StandardType; |
Kuwaiti Standard |
This International Standard describes positional tolerancing. This tolerancing method is applied to the location of a
point, of a line nominally straight and of a surface nominally plane, e.g. the centre of a sphere, the axis of a hole or
shaft and the median surface of a slot.
NOTE Profile tolerancing is used when lines are not intended to be straight or surfaces are not intended to lie in a plane;
see ISO 1660.
|
|
|
|
Decision No |
94/2013 |
|
|
Decision By |
From Ministers Office |
|
|
Date of Meeting |
13-08-2025 |
|
|
Approval Date |
|
|
|
Decision Date |
31-03-2013 |
|
|
Newspaper Publication Date |
|
|
|
Newspaper Number |
|
|