|
Technical Committee No |
TC01 |
|
Status |
Active |
|
Category |
Chemical And Textile Sector |
|
Sub Category |
|
|
$Resources:StandardType; |
Kuwaiti Standard |
This International Standard specifies requirements for materials used for moulded seals made of
thermoplastic elastomers (TPEs) for joints in:
a) thermoplastic piping systems for non-pressure waste water discharge (intermittent flow at up to 95 °C)
inside buildings;
b) thermoplastic piping systems for non-pressure underground drainage and sewerage (continuous flow at
up to 45 °C and intermittent flow at up to 95 °C);
c) thermoplastic rainwater piping systems.
General requirements for finished joint seals are also given; any additional requirements called for by the
particular application are specified in the relevant product standards taking into account that the performance
of pipe joints is a function of the seal material properties, seal geometry and pipe joint design.
|
|
|
|
Decision No |
37/2010 |
|
|
Decision By |
From Ministers Office |
|
|
Date of Meeting |
17-10-2009 |
|
|
Approval Date |
15-09-2010 |
|
|
Decision Date |
|
|
|
Newspaper Publication Date |
19-10-2010 |
|
|
Newspaper Number |
37/2010 |
|