StandardDetails

1.1 This specification covers a group of requirements that are mandatory for castings produced by the investment casting process to meet the metallurgical requirements of the following steel casting specifications issued by ASTM. ASTM Designation Title of Specification A27/A27M Steel Castings, Carbon, for General Application A128/A128M Steel Castings, Austenitic Manganese A148/A148M Steel Castings, High-Strength, for Structural Purposes A297/A297M Steel Castings, Iron-Chromium and Iron- Chromium-Nickel, Heat-Resistant, for General Application A447/A447M Steel Castings, Chromium-Nickel-Iron Alloy (25-12 Class), for High-Temperature Service A494/A494M Castings, Nickel and Nickel Alloy A560/A560M Castings, Chromium-Nickel Alloy A732/A732M Castings, Investment, Carbon and Low Alloy Steel for General Application, and Cobalt Alloy for High Strength at Elevated Temperatures A743/A743M Castings, Iron-Chromium, Iron-Chromium- Nickel, Corrosion-Resistant, for General Application A744/A744M Castings, Iron-Chromium-Nickel, Corrosion Resistant, for Severe Service A747/A747M Steel Castings, Stainless, Precipitation Hardening A890/A890M Castings, Iron-Chromium-Nickel- Molybdenum Corrosion-Resistant, Duplex (Austenitic/Ferritic) for General Application A915/A915M Steel Castings, Carbon and Alloy, Chemical Requirements Similar to Standard Wrought Grades A958 Steel Castings, Carbon and Alloy, with Tensile Requirements, Chemical Requirements Similar to Standard Wrought Grades A1002 Castings, Nickel-Aluminum Ordered Alloy 1.2 This specification also covers a group of supplementary requirements that may be applied to the above specifications as indicated therein. These are provided for use when additional testing or inspection is desired and apply only when specified individually by the purchaser in the order. 1.3 When investment castings are ordered, the requirements stated in this specification form an integral part of the material specification. In cases of conflict, the requirements of this specification shall take precedence over the individual material specification requirements. 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.